• Matek F405 AIO F4 Betaflight Flight Control Board with PDB

    Click image to enlarge
    - Matek F405 AIO F4 Betaflight Flight Control Board with PDB 6 in stock
    £31.80 (Incl. VAT)
    Qty - +
    PayPal credit available

    Matek F405 AIO F4 Betaflight Flight Control Board with PDB and F4 technology supplied with matek rubber mounts.

    This is the All-in-one (AIO) F4 FC by Matek, combing a F405 FC and PDB together, built-in BetaFlight OSD, Dual BEC 5V/2A & 9V/2A, SD card slot for Blackbox and current sensor.

     

    Specifications:
    Target : MATEKF405
    MCU : 168MHz STM32F405
    IMU : 32K ICM20602 accelerometer/gyro (SPI)
    Max. 32K Gyro update & 16K PID Loop
    OSD : BetaFlight OSD w/ AT7456E chip
    Blackbox: MicroSD card slot (SD/SDHC)
    VCP, UART1, UART2, UART3, UART4, UART5
    Built in inverter for SBUS input (UART2-RX)
    PPM/UART Shared : UART2-RX
    SoftSerial on S5 & S6 optional
    Smartaudio & Tramp VTX protocol supported
    Spektrum BIND_PIN : RX4
    WS2812 Led Strip : Yes
    Beeper : Yes
    RSSI : Yes
    * If Gyro 32kHz & PID loop 16kHz, Blackbox logging rate 1kHz Max.

     

    PDB Specifications:
    Input : 9~27V (3~6S LiPo) w/TVS protection
    PDB : 4x30A (Max.4x50A), 6 layers*2oz copper PCB
    Dual BEC : 5V/2A & 9V/2A
    LDO 3.3V : Max.300mA for Spektrum RX
    Current Sensor 200A (Scale 165)
    Battery Voltage Sensor : 1:10 (Scale 110)
    General Specifications
    2x LEDs for FC STATUS (Blue, Red)
    6x PWM / DShot outputs without conflict
    5x UARTs
    1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
    4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
    1x pair I2C1 pads (for INAV firmware only)
    1x Side-press button for BOOT(DFU) mode
    36x51mm PCB with 30.5mm mounting holes & XT60 socket
    12g