Luna II
Due to popular demand T9 are now importing the Luna II and Luna E All moulded Glider
Now in stock £279.99, P+P £18.99
The Luna glider has built a reputation on the slopes for being the best value mouldie available. A quality finish and fit with easy installation has made the Luna a favorite for an introductory model into moulded glider, sailplanes and good allround sporster appealing to most slope flyers!
Wing span: 2000mm
Aerofoil: MH32
Wing area: 43.8dm/sq
Flying weight: 1250g/1450g
The 2 piece 2 metre wing and Xtail makes the Luna easy to store and transport
Luna build (Courtesy Of Soaring Composites)
Control Throws
( + is down)
Elevator +10 -10
rudder +16 -16
ailerons -16 +9
Crow landing: flaps +35 ,aileron -18 .elevator +7
normal flying incidence 1mm
cg 95-102mm
Fuselage
Cut out servo bay, approx 40mm out
Cut out rest of fuse opening, make two plywood support for servos
Glue in plywood
Glue in nose cone
Measure and mark elevator incidence
Cut rod to length and glue in with epoxy/FG mix
Ball link for rudder or normal horn can be used
Fuse done
Wings
Cut out a FG patch and glue it in. This step is optional as i found the bays are already quite strong
Drill and cut out the wings for the flaps control rod
Flap clevis dremelled away a small portion to get enough clearance. Horns also angled forward at 30degree
Glue in flaps servo with horn attached
Glue in aileron servo with horn attached
Make connectors for easy assembly and add the servo covers
Finish up with some polish!
Looking pretty by the reservoir
A Example of Ballast Tube Fitout By Gareth White:
